This page contains the following types of installation information:
A. Spring Roller Installation
B. Spring Roller Tension Adjustment Procedure
C. Clutch Control Installation
D. Clutch Control/Fascia Installation
E. How To Correct A Shade If Going Up Crooked
A. Spring Roller Installation
| How to Install Spring Roller Window Shades |
| All custom made spring roller shades are regular roll mount, unless reverse roll mount is specified. |
|
|
| Standard Installation: Inside or Outside Brackets |
|
|
| 1. |
Bracket with open slots on the left side. |
| 2. |
Bracket with round mounts on the right side. |
| 3. |
Hold rolled up shade in position where brackets are to be installed. |
| 4. |
Mark location where brackets are to be installed. |
| 5. |
Screw brackets in place using two screws per bracket. Make sure brackets are level. |
| 6. |
Hang shade in brackets. Insert pin end of shade first in right bracket with round hole, then place other end in open slot bracket. |
| 7. |
Shade is ready to operate. |
| |
|
|
|
| Reverse Roll Mounted Shades |
| Outside Installation |
| 1. |
Bracket with open slots on the right side. |
|
Bracket with round mounts on the left side. |
|
Position brackets and proceed as in points 3 through 7 above. |
|
|
| Inside Installation |
| 2. |
Bracket with open slots on the left side. |
|
Bracket with round mounts on the right side. |
|
Position brackets and proceed as in points 3 through 7 above. |
|
|
|
Note: Rectangular end (spring end) of shade roller is inserted first into right side bracket with hole. Round pin end slips into open slot bracket on left side. |
B. Spring Roller Tension Adjustment Procedure
C. Clutch Control Installation Procedure
Caution: When pulling the shade up and down use both hands. One hand should be on the front of the bead chain and the other placed on the back side of the bead chain.
D. Clutch Control / Fascia Installation
Caution: When pulling the shade up and down use both hands. One hand should be on the front of the bead chain and the other placed on the back side.
E. How To Correct A Shade If Going Up Crooked
1. Check to see if the brackets are installed level. If not reinstall brackets
2. If step 1 does not cure the problem, proceed with the following:
Remove the shade (in the completely rolled up position) from the brackets. Before doing so, make a note of which side the shade is rolling up towards.
Roll the shade out on a table until the roller is exposed. Where the fabric touches the roller, on the side opposite to which the shade was going up on an angle, place a three inch piece of masking tape lengthwise along the fabric. Re-roll the shade and place back in the brackets. This procedure might have to be repeated with additional tape.
Please note: All spring roller shades should be guided up and down straight by the operator. This is particularly true if the height of the window is more than two and one half times its width.
